11 22 513 Replacing roller bearing for dual-mass flywheel (N20, N26)

Special tools required:

NOTE: FLYWHEEL removed!

Using hydraulic press (1) and special tool 21 2 051 , press roller bearing out of dual-mass flywheel downwards on engine side.

IMPORTANT: Risk of damage:
Roller bearing must not be driven out.

Fig 1: Pressing Roller Bearing Using Hydraulic Press

Courtesy of BMW OF NORTH AMERICA, INC.

Push roller bearing (2) onto special tool 21 2 052 .

Using hydraulic press (1), press roller bearing into dual-mass flywheel to limit position on clutch side.

IMPORTANT: Risk of damage:
Observe press-in instruction:

Roller bearing must not be driven in.
Roller bearing mounting force/travel monitored:
Min. 2000 N 1 mm before end of pressing in.

Max. 15, 00 N during entire press-in procedure.

Fig 2: Pressing Roller Bearing Using Hydraulic Press

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Assemble engine.