11 11 Engine Block, Cylinder Crankcase N54 B30
WARNING: This page is about a different variant/trim than selected.
ENGINE BLOCK, CYLINDER CRANKCASE SPECIFICATIONS
| Bore _ stage 0a) | mm | 84.000+0.014 |
| Bore _ stage 00 a) | mm | |
| Bore _ stage 1 a) | mm | 84.250+0.014 |
| Permitted out-of-round of cylinder bore a) | mm | 0.005 |
| Permitted conicity of cylinder bore a) | mm | 0.01 |
| Permissible total wear tolerance between piston and cylinder (engine operated) | mm | 0.15 |
a) new status or recondition