11 12 Cylinder Head with Cover N54 B30
WARNING: This page is about a different variant/trim than selected.
CYLINDER HEAD WITH COVER SPECIFICATIONS
| Cylinder head height: Original dimension | mm | 112.00 ± 0.05 |
| Machining limit | mm | 111.70 ± 0.05 |
| Valve guides are not available as replacement parts. | ||
| Inside diameter of installed valve guide | ||
| Original inlet valve | mm | 5.0+0.012 |
| Original exhaust valve | mm | 6.0+0.012 |
| Tilt clearance, maximum (wear between valve and valve guide) | mm | cannot be measured |
| Bearing of camshaft | ||
| Guide bearing (width) | mm | 22.000...22.052 |