28 40 020 Removing and installing or replacing clutch support (GS7D36SG)
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
After completion of work, check oil level .
.
Use only the approved DCTF-1 Pentosin (P/N 83 22 2 147 477).
Failure to comply with this instruction will result in serious damage to the twin-clutch gearbox.
Use only the approved DCTF-1 Pentosin (P/N 83 22 2 147 477).
Failure to comply with this instruction will result in serious damage to the twin-clutch gearbox.
IMPORTANT:
Read and comply with notes on ESD PROTECTION (ELECTRO STATIC DISCHARGE)
.
Necessary preliminary work
- Remove twin-clutch gearbox
- Remove clutch
Remove pump unit .
Unfasten screws (2).
Remove clutch support (3).
Installation note:
Replace screws and seal.
IMPORTANT:
Before installing clutch support:
Make sure without fail that seal (1) is installed in correct position and piston rings are correctly fitted on drive shaft.
Secure clutch support screw connections in diagonal sequence.
Make sure without fail that seal (1) is installed in correct position and piston rings are correctly fitted on drive shaft.
Secure clutch support screw connections in diagonal sequence.