28 10 020 Removing and installing or replacing combination sensor (GS7D36SG)
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
After completion of work, check oil level . .
Use only the DCTF-1 Pentosin (P/N 83 22 2 147 477).
Failure to comply with this instruction will result in serious damage to the twin-clutch gearbox.
Use only the DCTF-1 Pentosin (P/N 83 22 2 147 477).
Failure to comply with this instruction will result in serious damage to the twin-clutch gearbox.
IMPORTANT:
Read and comply with notes on ESD PROTECTION (ELECTRO STATIC DISCHARGE)
.
Necessary preliminary work
- Remove twin-clutch gearbox
- Remove clutch
Release screw (1).
Release combination sensor (2) from housing.
Disconnect connector (3).
Installation note:
Replace screw.
IMPORTANT:
Do not
where possible release cable (4) from bracket (5).
Installation note:
If bracket (5) does have to be released, replace aluminum screw (6).
Tightening torque, see 28 10 11AZ in 28 10 HOUSING WITH ADD-ON PARTS .
IMPORTANT:
To disconnect the combination sensor connector:
Press lock together in area (1) and simultaneously detach connector.
Press lock together in area (1) and simultaneously detach connector.