22 11 100 Replacing right engine support arm (N54)
WARNING: This page is about a different variant/trim than selected.
Necessary preliminary tasks
- Secure engine in INSTALLATION POSITION
- Remove REAR UNDERBODY PROTECTION and FRONT UNDERBODY PROTECTION .
- Remove both catalytic converters. See 1832050 REMOVING AND INSTALLING/REPLACING CATALYTIC EXHAUST-GAS CONVERTER FOR CYLINDERS 1-3 (N54) or 1832060 REMOVING AND INSTALLING/REPLACING CATALYTIC EXHAUST-GAS CONVERTER FOR CYLINDERS 4-6 (N54) .
Release screws (1).
Remove engine support arm from engine.
Tightening torque 22 11 3AZ