22 11 001 Replacing right engine mount (N54)

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks

Release screws (1) and remove engine mount.

Tightening torque 22 11 1AZ .

Fig 1: Identifying Engine Mount Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Stop (1) is mounted on engine support arm.

Fig 2: Identifying Engine Support Arm Stop

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Rubber section (1) of engine mount must point to middle of vehicle.

Fig 3: Identifying Engine Mount Rubber Section

Courtesy of BMW OF NORTH AMERICA, INC.