21 00 006 Bleeding clutch hydraulics (plastic slave cylinder)

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks

Connect bleeder unit to brake fluid expansion tank.

IMPORTANT: Check relevant Operating Instructions for each device.

Charging pressure should not exceed 2 bar.

Connect bleeder hose to bleed valve (1).

Open bleed valve (1) and flush until clear brake fluid emerges without air bubbles.

Close bleed valve.

Fig 1: Identifying Bleed Valve

Courtesy of BMW OF NORTH AMERICA, INC.

Switch off bleeder unit or remove from brake fluid expansion tank.

Correct brake fluid level in expansion tank.