23 12 510 Replacing radial shaft seal for drive shaft (GS6-53BZ/DZ)
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
After completion of work, check TRANSMISSION FLUID LEVEL
.
Use only approved MANUAL TRANSMISSION - OPERATING FLUID .
Failure to comply with this instruction will result in serious damage to the transmission.
Necessary preliminary tasks
- Remove TRANSMISSION .
- Remove CLUTCH RELEASE UNIT AND RELEASE LEVER from guide tube.
Release screws.
Tightening torque: 23 11 2AZ .
Remove guide tube (1).
Installation:
Clean guide tube.
Do not grease guide tube.
Release screw on special tool 23 3 200 .
Push special tool onto drive shaft and screw into sealing ring.
Insert screw into special tool 23 3 200 again and continue turning until sealing ring is pulled out of transmission housing.
Installation
Coat sealing lips of radial seal with gear oil.
Push radial seal (1) onto drive shaft up to housing.
Drive in radial seal (1) as far as it will go with special tool 23 3 220 and plastic hammer.