23 00 037 Installing replacement transmission (GS6-53BZ/DZ)
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
After completion of work, check TRANSMISSION OIL LEVEL
.
Use only the approved transmission fluid. See MANUAL TRANSMISSION - OPERATING FLUIDS .
Failure to comply with this instruction will result in serious damage to the transmission.
Recycling
Catch and dispose of escaping transmission fluid.
Observe country-specific waste-disposal regulations
Necessary preliminary tasks
- Drain gear oil at oil drain plug. Tightening torque: 23 00 4AZ .
- REMOVE TRANSMISSION .
If necessary, unfasten screws.
Remove and convert transmission bearing block.
Tightening torque 22 32 2AZ .
NOTE:
Illustration shows E46.
Convert shift rod joint.
Push back retaining ring (1) and drive out dowel pin (2).
NOTE:
Check damping disk (6) for damage and replace if necessary.
Convert following parts from previous transmission to new transmission.
- RELEASE BEARING AND RELEASE LEVER .
- Ball pin and spring wire clip
- Studs for clutch slave cylinder.
Check oil level.
Installation:
Observe greasing specification. See MANUAL TRANSMISSION - OPERATING FLUIDS .