13 54 030 Removing and installing/sealing throttle valve assembly (N54)

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Read and comply with notes on ESD PROTECTION (ELECTRO STATIC DISCHARGE) .

Necessary preliminary tasks

Unlock and disconnect line (1).

Unlock connector (2) and remove.

Release screws.

Tightening torque 13 54 1AZ .

Remove throttle assembly (3).

Fig 1: Locating Throttle Assembly And Connector

Courtesy of BMW OF NORTH AMERICA, INC.

Installation

Replace sealing ring (1) of throttle assembly (2).

Fig 2: Identifying Sealing Ring Of Throttle Assembly

Courtesy of BMW OF NORTH AMERICA, INC.

Installation

Check stored fault messages.

Now clear the fault memory.