11 22 500 Removing and installing/replacing flywheel (N54, N54T)
WARNING: This page is about a different variant/trim than selected.
Necessary preliminary tasks:
- Remove TWIN-CLUTCH GEARBOX (GS7D36SG) N54
- Remove CLUTCH
Enlarge special tool 11 9 260 with an elongated hole.
Enlarge elongated hole on special tool 11 9 260 to 8 mm .
For vehicles with manual gearboxes
Secure flywheel with special tool 11 9 260 .
Release flywheel bolts with special tool 11 4 180 /
Tightening torque 11 22 2AZ .
Installation note:
The flywheel is secured with a dowel pin.
Fit new flywheel screws
For vehicles with automatic transmissions
Secure flywheel with special tool 11 9 260 .
Release flywheel screws with a suitable tool (1).
Tightening torque 11 22 1AZ .
Installation note:
The flywheel is secured with a dowel pin.
Fit new flywheel screws
Assemble engine.