12 61 280 Removing and installing/replacing oil pressure sensor (N54)
WARNING: This page is about a different variant/trim than selected.
Necessary preliminary tasks
- Switch off ignition
- Remove ACOUSTIC COVER
WARNING:
Scalding hazard!
Only perform this task on an engine that has cooled down.
Installation location
Oil filter housing, front left.
Engine oil may emerge when oil pressure sensor is replaced; have a cleaning cloth ready.
Unlock plug (1) and remove.
Release oil pressure sensor (2).
Tightening torque, 12 61 1AZ .
Installation:
Check engine oil level, top up engine oil if necessary.