12 14 651 Replacing suction pressure sensor on charge-air duct (N54)

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks

NOTE: The installation location of the suction pressure sensor is at the rear end of the charge-air duct.

Unlock plug (1) and remove.

Release screws and pull suction pressure sensor (2) out of charge-air duct.

Tightening torque 13 62 2AZ .

Fig 1: Identifying Suction Pressure Sensor And Plug

Courtesy of BMW OF NORTH AMERICA, INC.

Installation

Check sealing ring for damage. Replace sealing ring if damaged.

When installing, coat sealing ring with suitable antiseize agent.

Fig 2: Locating Sealing Ring

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Add final details to vehicle.
Check stored fault messages.
Now clear the fault memory.