Topping up transmission oil after a repair
WARNING: This page is about a different variant/trim than selected.
Stand vehicle on a level surface and secure against rolling off.
- Open fluid adjusting screw (1). If oil emerges, close screw again immediately
If no oil emerges, top up until oil emerges and close oil adjusting screw (1) again
NOTE: If oil has been replenished here, a further refill must be carried out during the actual oil adjustment. - Connect diagnosis system and start service functions (drive).
- Start engine (drive position N or P)
- Record transmission temperature using Tester.
- (Drive position P)
- Permissible starting temperature ≤ 32°C
- Idle speed: maintain at approx. 2000 RPM for 1 minute.
- Open the oil adjusting screw (1)
- Fill until oil emerges.
- Insert screw.
Max. transmission oil temperature 40 degrees Celsius
Installation note:
Replace screw.