Checking oil level
WARNING: This page is about a different variant/trim than selected.
- Call up Service functions (Drive) in BMW diagnosis system
- Carry out oil level check in accordance with instructions
IMPORTANT:
On the twin-clutch gearbox a run-in check fluid change is not
required at 2000 km.
Use only the approved gear oil for dual clutch transmission GS7D36SG .
Failure to comply with this instruction will result in serious damage to the twin-clutch gearbox.
IMPORTANT:
The testing and filling procedure must
be completed before the transmission oil temperature of 40°C is reached.
If a temperature in excess of 40°C is reached and no oil has emerged, insert the fluid adjusting screw and repeat the testing and filling procedure when it has cooled down.
Installation note:
Tighten down filler plug using
- Hexagon wrench 8 A/F
- Torque wrench
- Socket 8 A/F