23 21 Transmission Shafts
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATION - TRANSMISSION SHAFTS
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Output flange | S5D 200G/S5D 250G/S5D260Z/S5D 310Z/S6S 420G | Collar nut installed with bolt cement | ||
| Pretension Release |
190 Nm | |||
| Tighten down | 120 Nm | |||
| S5D 280Z/S5D 320Z | Collar nut installed with bolt cement | |||
| Pretension Release |
170 Nm | |||
| Tighten down | 130 Nm | |||
| S5D 390Z | Collar nut installed with bolt cement | |||
| Pretension Release |
200 Nm | |||
| Tighten down | 145 Nm | |||
| GS6-37BZ/GS6-17BG | Collar nut installed with bolt cement | |||
| Pretension Release |
170 Nm | |||
| Tighten down | 120 Nm | |||
| GS6-53DZ | Collar nut installed with bolt cement | |||
| Pretension Release |
200 Nm | |||
| Tighten down | 140 Nm | |||
| GS7S47BG | Collar nut installed with bolt cement | 200 Nm | ||
| 2AZ Gear to countershaft | 265/Sport | M10 | 60 Nm |