23 00 Transmission in general
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATION - TRANSMISSION IN GENERAL
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 2AZ Transmission to clutch housing | B/C/D/E/F/G/H/I/7-speed SMG | M12 | 76 Nm | |
| 3AZ Reinforcement plate to transmission | B/C/D/E/F/G/H/I/7-speed SMG | M8 | 23 Nm | |
| 4AZ Oil drain plug/filler plug | B/C-transmission | 50 Nm | ||
| D/E-transmission | 52 Nm | |||
| G/H-transmission | M18x1.5 hexagon socket | 35 Nm | ||
| H/I-transmission | M12x1.5 | 25 Nm | ||
| I transmission | M18x1.5 | Steel screw without seal | 45 Nm | |
| 7-speed SMG | 40 Nm | |||
| 5AZ Transmission extension | g/H transmission | M10 | 46 Nm |
TIGHTENING TORQUE SPECIFICATION - TRANSMISSION IN GENERAL
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 6 KT-Schrauben | B/C/D/E/F/G/H/I/7 Gang SMG | M6 | 8 Nm | |
| B/C/D/E/F/G/H/I/7 Gang SMG | M8 | 25 Nm | ||
| B/C/D/E/F/G/H/I/7 Gang SMG | M10 | 49 Nm | ||
| B/C/D/E/F/G/H/I/7 Gang SMG | M12 | 74 Nm | ||
| Torx-Schraube | B/C/D/E/F/G/H/I/7 Gang SMG | M6 | 9 Nm | |
| B/C/D/E/F/7 Gang SMG | M8 | 19 Nm | ||
| B/C/D/E/H/I/7 Gang SMG | M10 | 43 Nm | ||
| G-Getriebe | M10 | 38 Nm | ||
| 7 Gang SMG | M10x55 8.8 | 43 Nm | ||
| 7 Gang SMG | M10x42 8.8 | 42 Nm | ||
| Stahlschrauben mit Torx-Kopf | I/G/H-Getriebe | M8 | 19 Nm | |
| Stahlschrauben mit Torx-Kopf | I/G/H-Getriebe | M12 | 66 Nm | |
| 2Az Transmission to N52/N52K/N53/N54 aluminium screws/bolts are not magnetic. | I/G/H-transmission | Replace screws Jointing torque and angle of rotation must be observed without fail |
||
| I/G/H-transmission | M10x30 | Jointing torque Angle of rotation |
20 Nm 90 - -110° |
|
| I/G/H-transmission | M10x85 | Jointing torque Angle of rotation |
20 Nm 180 - -200° |
|
| I/H/G-transmission | M12 | Jointing torque Angle of rotation |
25 Nm 130° +20° |
|
| 3AZ Cover plate, transmission | I/H-transmission | M6 | 8 Nm |