23 11 Case and Cover
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATION - CASE AND COVER
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 16AZ Holder to transfer case | 265/Sport | M6 | 9 Nm | |
| 17AZ Retaining plates for bearings on housing | S5D 310Z/S5D 320Z/S5D 200G/S5D 250G | M6 | 10 Nm | |
| 18AZ Retaining plate to housing | S5D 320Z SMG | M6 | 5.5 Nm |
TIGHTENING TORQUE SPECIFICATION - CASE AND COVER
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Transmission housing, rear section/front section | B/C/D/E/F/G/H/I/7-speed SMG | 22 Nm | ||
| 2AZ Cover with guide tube/transmission case | B/C/D/E/F/G/H/I/7-speed SMG | M8 x 22 | 18 Nm | |
| B/C/D/E/F/G/H/I/7-speed SMG | M8 x 30 | 25 Nm | ||
| B/C/D/E/F/G/H/I/7-speed SMG | M6 | 10 Nm | ||
| 3AZ Bearing cap/sealing flange | B/C/D/E/F/G/H/I/7-speed SMG | 10.5 Nm | ||
| 4AZ Reverse gear wheel axle to intermediate housing | B/C/D/E/F/G/H/I/7-speed SMG | 49 Nm | ||
| 5AZ Retaining plate for reverse gear wheel axle to intermediate housing | B/C/D/E/F/G/H/I/7-speed SMG | 25 Nm | ||
| 6AZ Transmission closing plate | B/C/D/E/F/G/H/I/7-speed SMG | M6 | 8 Nm |