13 62 Senders for Control Unit
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATION - SENDERS FOR CONTROL UNIT
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Coolant temperature sensor | N54 | M12x1.5 | 13.5 Nm | |
| 2AZ Intake pressure sensor | N54 | K50x16 | 3.75 Nm | |
| 3AZ Camshaft sensor to cylinder head | N54 | M6x16 | 8 Nm | |
| 4AZ Crankshaft sensor to crankcase | N54 | M6x16 | 8 Nm | |
| 5AZ Knock sensor to crankcase | N54 | M8x30 | 21.5 Nm |
TIGHTENING TORQUE SPECIFICATION - SENDERS FOR CONTROL UNIT
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Temperature time switch | M21/M51 | 18 Nm | ||
| 2AZ Temperature sensor, water | M60/1/M60/2/M21/M51 | 18 Nm | ||
| all others | 13 Nm | |||
| 3AZ Temperature switch | All | 28 Nm | ||
| 4AZ Temperature sensor, air | All | 13 Nm | ||
| 5AZ Charge-air pressure sensor to bracket | M51/M41 | 4 Nm | ||
| Charge-air pressure sensor to intake manifold | M47 | 5 Nm | ||
| 6AZ Dual temperature sensor (4-pin plug connection) | M41/M43/M44/S50/S52/M52/M57/M67/M62/M73 | 13 Nm | ||
| 7AZ Air-mass sensor on lower section of intake filter housing | M51 | 3.5 Nm | ||
| Air-mass flow sensor to cylinder head cover | M47/M47TU/M57/M57TU/M57T2 | 4.5 Nm | ||
| 8AZ Pulse generator, camshaft to cylinder head cover | M57 | 4.5 Nm | ||
| M47TU/M57TU | 3.5 Nm | |||
| M57T2 | 2.3 Nm | |||
| 9AZ Intake neck on air-mass flow sensor | M47 | 9 Nm |