13 71 Air intake silencer
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATION - AIR INTAKE SILENCER
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Clean-air gaiter to throttle valve | N52K | Hose clamp | 3 Nm | |
| 2AZ Gaiter to intake muffler | N52K | Hose clamp | 3 Nm | |
| 3AZ Intake silencer to body | N52K | M6 | 8 Nm | |
| 4AZ Intake duct to front wall | N52K/N54 | self-tapping screw | 2 Nm | |
| 5AZ Air duct to air silencer | N54 | Hose clamp | 3 Nm | |
| 6AZ Air duct to crankcase | N54 | M6 | 9 Nm | |
| 7AZ Charge-air duct to bracket | N54 | M6 | 9 Nm | |
| 8AZ Air duct, compressor to basic engine | N54 | M6 | 9 Nm | |
| 9AZ Pressure sensor to charge-air duct | N54 | M6 | 2 Nm | |
| 10AZ Engine sound system to charge-air duct | N54 | Hose clamp | 3 Nm | |
| 11AZ Engine sound line to sound system | N54 | Hose clamp | 3 Nm | |
| 12AZ Holder for air duct to cylinder head | N54 | M6 | 9 Nm | |
| 13AZ Air intake hose to throttle valve assembly | N52K | Hose clamp | 3 Nm |