11 36 Variable Camshaft Control
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATION - VARIABLE CAMSHAFT CONTROL
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ VANOS with sensor wheel to inlet and exhaust camshafts | N54 | M10x94 | Replace screw | |
| Jointing torque | 20 Nm | |||
| Torque angle | 180 ° | |||
| 2AZ Non-return valve VANOS to cylinder head | N54 | M14 x 1.5 | 13 Nm | |
| 3AZ Solenoid valve holder to cylinder head | N54 | M6x12 | 10 Nm |