11 12 Cylinder Head And Cylinder Head Cover
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATION - CYLINDER HEAD WITH COVER
| Type | thread | tightening specification | Measure | |
|---|---|---|---|---|
| 11AZ Cylinder head cover | All | M6 | 10 Nm | |
| All | M7 | 15 Nm | ||
| M21 | M8 | 15 Nm | ||
| 12AZ Oil trap to cylinder head cover | M21 | M8 | 17 Nm | |
| 13AZ Timing case to cylinder head | All | M7 | 15 Nm | |
| All | M8 | 20 Nm | ||
| 14AZ Plug for oil channel (microencapsulated) | M47/M57 | M12 x 1.5 | 20 Nm | |
| 15AZ Vent plugs to cylinder head (coolant) | M67 | 2 Nm |
TIGHTENING TORQUE SPECIFICATION - CYLINDER HEAD WITH CYLINDER HEAD COVER
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Cylinder head bolt | N54 | M11 x 135 | Replace screws. | |
| Jointing torque | 30 Nm | |||
| 1st angle of rotation | 90 ° | |||
| 2. Angle of rotation | 90 ° | |||
| 3. Angle of rotation | 45 ° | |||
| 2AZ Cylinder head bolt | N54 | M9 x 95 M9 x 125 |
Replace screws. | |
| Jointing torque | 30 Nm | |||
| 1st angle of rotation | 90 ° | |||
| 2. Angle of rotation | omitted | |||
| 3. Angle of rotation | 45 ° | |||
| 3AZ Cylinder head bolt | N54 | M9 x 30 M9 x 70 |
22 Nm | |
| 4AZ Cylinder head cover to cylinder head. | N54 | M6 | 8.5 Nm | |
| 5AZ Metal bracket to cylinder head. | N54 | M6 x 16 | 8 Nm | |
| 6AZ Lifting eye to cylinder head. | N54 | M8 x 20 | 19 Nm | |
| 7AZ Ignition coil cover to cylinder head cover. | N54 | M6 x 20 | 4 Nm | |
| 8AZ Hexagon screw (2 x) Metal bracket for ignition coil cover to cylinder head cover. |
N54 | M6 x 12 | 4 Nm |