11 21 Crankshaft and Bearings
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATION - CRANKSHAFT AND BEARINGS
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Torsion damper (hub) to crankshaft (central bolt 12.9) |
N54 | M16x80 | Replace screws Lightly oil screws and threads |
|
| Jointing torque | 100 Nm | |||
| Torque angle | 360 ° |
TIGHTENING TORQUE SPECIFICATION - CRANKSHAFT AND BEARINGS
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Increment wheel on crankshaft | S54 | M5 10.9 | Replace screws | |
| Jointing torque | 5.0 Nm | |||
| Torque angle | 45 ° | |||
| Increment wheel on crankshaft | M5 10.9 | Replace screws | 13 Nm | |
| Increment wheel on crankshaft | M5 8.8 | Replace screws | 5.5 Nm |