11 51 Coolant pump with drive
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATION - COOLANT PUMP WITH DRIVE
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Coolant pump to crankcase | N54 | M8 x 26 | Replace screws. Thread repairs exclusively with aluminum Helicoil threaded insert. Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 10 Nm | |||
| Torque angle | 90 ° | |||
| 2AZ ASA screw Coolant pump to bracket. |
N54 | M8 x 27 | 20.5 Nm | |
| 3AZ Hose clamp Coolant hose between coolant pump and coolant thermostat. |
N54 | L42-48 | 3 Nm | |
| 4AZ Hose clamp Coolant hose between coolant pump and feed line. |
N54 | L42-48 | 3 Nm |