13 62 560 Removing and installing/replacing left or right hot film air mass meter (N63O1)

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Read out fault code memory of the DME control unit.
Switch off ignition
Remove ACOUSTIC COVER

Picture shows the left side, the procedure for the right side is identical.

Unlock connector (1) and remove.

Unfasten screws (2).

Tightening torque 13 62 6AZ .

Pull hot film air mass meter (3) out of upper section of intake silencer housing.

Installation note:

Replace gasket on hot film air mass meter.

Fig 1: Identifying Hot Film Air Mass Meter, Connector And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Check stored fault message.

Clear diagnostic fault entries from fault memory.