17 13 020 Removing and installing/replacing expansion tank for charge air cooler (S63)

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Risk of scalding!
Only perform this repair work after engine has cooled down.

Necessary preliminary tasks:

Follow instructions for REPAIR WORK ON THE COOLING SYSTEM .
Remove ACOUSTIC COVER
Disconnect coolant hose (not plastic tubes ) from expansion tank for charge air cooler.

Release screw (1).

Tightening torque 17 10 6AZ .

Slightly raise expansion tank (3).

Release and disconnect coolant hoses (2).

Fig 1: Identifying Expansion Tank, Coolant Hoses And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Press in locks (1) and pull off tank ventilation lines (2).

Do not use disconnection pliers to disconnect plastic tubes!

Catch and dispose of escaping coolant.

Remove charge air cooler expansion tank.

Fig 2: Identifying Tank Ventilation Lines And Locks

Courtesy of BMW OF NORTH AMERICA, INC.

After completing repair work, top charge air cooler up with coolant.

Check cooling system for charge air cooler for leaks.