17 11 035 Removing and installing/replacing fan cowl with electric fan (S63)
WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary work:
- Read out the fault memory of the DME control unit.
- Switch off ignition.
- Remove CROSS CONNECTION .
- Remove STIFFENING PLATE
IMPORTANT:
Ensure that no coolant enter into the plug connection of the auxiliary coolant pump.
Check plug connection for coolant residues. If necessary, blow clean plug connection with compressed air.
Check plug connection for coolant residues. If necessary, blow clean plug connection with compressed air.
Release screw (1).
Tightening torque 17 10 3AZ .
Release holder (1) for auxiliary water pumps from fan cowl and module carrier to the top.
Unlock and pull off connector (1) and cable from fan cowl.
Release screws and clamps (2).
Tightening torque 17 10 7AZ .
Remove fan cowl (3) towards top.
Installation note:
Insert retaining tab (1) at bottom on module carrier.
NOTE:
Check stored fault message.
Reassemble the vehicle.
Delete fault memory.
Reassemble the vehicle.
Delete fault memory.