17 11 035 Removing and installing/replacing fan cowl with electric fan (N55)

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary work:

Turn off ignition
Remove CROSS CONNECTION

Release screw (1) on fan cowl.

Tightening torque 17 10 4AZ .

Detach charge air duct (2) from fan cowl.

Fig 1: Identifying Charge-Air Duct And Screw

G09876458

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock and disconnect plug (1) on fan cowl on right.

Fig 2: Identifying Plug On Fan Cowl

G09876459

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip fan cowl (1) at clamps (2) on left and right, feed out in upward direction and remove.

Fig 3: Removing Fan Cowl

G06889285

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Insert retaining tab (1) at bottom on module carrier.

Fig 4: Identifying Retaining Tabs

G04794056

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Check stored fault message.
Reassemble the vehicle.
Delete fault memory.