17 11 035 Removing and installing/renewing fan cowl with electric fan (N63)

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary work:

Switch off ignition.
Remove CROSS CONNECTION .
Remove INTAKE PORT on left and right.
Remove front UNDERBODY PROTECTION .

Detach coolant hose from fan cowl at retainer (1).

Fig 1: Identifying Coolant Hose Retainer

G06889282

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock and disconnect plug (1) on fan cowl.

Release screw (2) on holder for coolant hoses.

Tightening torque 17 10 5AZ .

Detach coolant hoses with holder from fan cowl.

Fig 2: Detaching Coolant Hoses From Fan Cowl

G06889283

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Tightening torque 17 10 3AZ .

Detach transmission oil cooler upwards from fan cowl.

Fig 3: Identifying Screw

G06889284

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip fan cowl (1) at clamps (2) on left and right, feed out in upward direction and remove.

Fig 4: Removing Fan Cowl

G06889285

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Insert retaining tabs (1) at bottom on module carrier.

Fig 5: Identifying Retaining Tabs

G04794056

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Check stored fault message.
Reassemble the vehicle.
Clear diagnostic fault entries from fault memory.