61 31 339 Replace the handle cover for the gear selector switch (Sport)

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 460

Lever out the display (1) with a suitable tool.

NOTE: Display (1) is glued on.

Installation note:

Remove the protective film from the back of the display before installing.

Make sure display (1) is correctly seated.

Fig 1: Removing Display

G10064234

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Tightening torque 61 31 5AZ .

NOTE: To tighten screws, use special tool 00 9 460 .

Fig 2: Identifying Screw

G10064235

Courtesy of BMW OF NORTH AMERICA, INC.

Zinc plated top shell design:

Remove top shell (1).

Fig 3: Removing Gear Selector Top Shell (Zinc Plated Top Shell Design)

G10064236

Courtesy of BMW OF NORTH AMERICA, INC.

Ceramic top shell design:

Remove top shell (1).

NOTE: Hold-down device (2) is seated loosely in the top shell (1).

Installation note:

Make sure hold-down device (2) is correctly seated in upper shell (1).

Fig 4: Removing Gear Selector Top Shell (Ceramic Top Shell Design)

G10064237

Courtesy of BMW OF NORTH AMERICA, INC.