67 10 522 Replacing (removing and installing) the drive unit for rear view camera

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary tasks:

Remove TRIM FOR REAR LID

Unlock plug connections (3) and (4) and disconnect.

Release screws (1) and (2).

Remove drive unit (5).

Fig 1: Identifying Drive Unit Plug Connections And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

The operation emblem (1) must be completely closed when installing the drive unit.

The operating lever (2) on the operating emblem (1) must be connected correctly with the guide in the drive unit.

Fig 2: Identifying Operating Lever And Operating Emblem

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Remount the REAR VIEW CAMERA .