51 45... Removing and installing/replacing side panel on dashboard (with switch for front passenger airbag deactivation) on the left and right

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 325

WARNING: Read and comply with SAFETY REGULATIONS for handling airbag modules and pyrotechnical belt tensioner.
Incorrect handling can activate airbag and cause injury.

When working on trim panel components, make sure that the sensitive surfaces are not scratched or damaged.

Necessary preliminary tasks:

Clamp off BATTERY NEGATIVE LEAD

Pull off sealing (2) in the area of the dashboard side panel (1).

Unclip side panel from dashboard (1) in direction of arrow with special tool 00 9 325 and feed out at a slant to the rear.

Fig 1: Identifying Dashboard Side Panel And Sealing

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Retaining clips (4) and guide tab (3) of side panel on dashboard (1) must not be damaged or missing.

Replacement

Reinstall retaining clips (4).
Modify SWITCH FOR FRONT PASSENGER AIRBAG DEACTIVATION (2)

Fig 2: Identifying Passenger Airbag Deactivation Switch And Retaining Clips/Guide Tab Of Dashboard Side Panel
Courtesy of BMW OF NORTH AMERICA, INC.