13 54 020 Removing and installing/sealing right throttle valve assembly (N63)

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Turn off ignition
Remove right INTERCOOLER

NOTE: Picture shows the left throttle valve assembly, the procedure for the right side is identical.

Unlock plug (1) and remove.

Unfasten screws (2).

Tightening torque 13 54 1AZ .

Remove throttle valve assembly (3).

Fig 1: Identifying Throttle Valve Assembly, Screws, Coolant Remnants Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Check plug connection (1) for coolant remnants. If necessary, clean plug connection (1) with compressed air.

Installation:

Replace sealing ring (1) of throttle assembly (2).

Fig 2: Identifying Throttle Assembly Sealing Ring

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Check stored fault message.

clear fault memory.