32 41 315 Replace intake pipe for hydraulic steering (from the connecting piece to the vane pump) (N63T)

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: DANGER OF POISONING if oil is ingested/absorbed through the skin!
RISK OF INJURY if oil comes into contact with eyes and skin!

IMPORTANT: Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Close off line connections with seal plugs.

Recycling:

Catch and dispose of hydraulic fluid in a suitable collecting vessel.

Necessary preliminary work:

Draw off and dispose of hydraulic fluid from oil reservoir
Remove INTAKE PORT
Lower FRONT AXLE SUPPORT

Release hose clamp (1) from out of the engine compartment.

Tightening torque 32 41 3AZ .

Release bolt (2) from out of vehicle underbody

Tightening torque 32 41 8AZ .

Installation note:

Replace hose clamp.

Fig 1: Identifying Hose Clamp And Bolt

Courtesy of BMW OF NORTH AMERICA, INC.

Release hose clamp (1) at the vane pump and pull off intake pipe from the vane pump.

Installation note:

Replace hose clamp.

Make sure hydraulic lines are laid without tension and with sufficient distance to adjoining components.

Align suction line by way of marking (2) to power steering pump connection marking.

Fig 2: Identifying Hose Clamp And Intake Pipe Marking

Courtesy of BMW OF NORTH AMERICA, INC.

Remove suction line (1) in direction of arrow from holder (2).

Remove intake pipe in upward direction.

Fig 3: Removing Suction Line

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

Fill and bleed hydraulic system . See 32 13 006 BLEEDING POWER STEERING (VERSION WITH DYNAMIC DRIVE) or 32 13 006 BLEEDING POWER STEERING UNIT
Check line connections for leaks