26 11 090 Removing and installing/replacing front centering mount for propeller shaft

WARNING: This page is about a different car, the 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

REMOVE PROPELLER SHAFT.

Completely fill centering bore (1) with viscous grease.

Drive special tool 11 1 310 with a plastic hammer into centering bore.

The centering mount (1) is forced out of the propeller shaft by the pressure on the grease filling.

If necessary, top up grease repeatedly.

NOTE: To drive out the mount, you can also fill the centering bore with water instead of grease.

Fig 1: Driving Centre Mount Using Special Tools 11 1 310 Into Propeller Shaft

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Remove grease/water from mount bore.

Drive in centering mount (1) with special tools 11 2 030 and 00 5 500 into propeller shaft (observe protrusion).

Grease centering mount.

Grease: see PROPELLER SHAFT - OPERATING FLUIDS .

Fig 2: Installing Centering Mount Using Special Tools (11 2 030 And 00 5 500)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation

Observe protrusion A = 4⁺² mm of centering (1).

Fig 3: Identifying Protrusion Of Centering

Courtesy of BMW OF NORTH AMERICA, INC.