22 31 001 Replacing rubber mount for transmission mounting (automatic transmission)
WARNING: This page is about a different car, the 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary work
- Remove rear UNDERBODY PROTECTION
- Remove heat shield
- Support transmission with jack.
Unfasten screws (1) and nuts (2).
Remove transmission cross member.
Remove rubber mount from transmission cross member.
Tightening torque 22 32 3AZ/4AZ .