21 00 006 Bleeding clutch hydraulics (plastic slave cylinder)

WARNING: This page is about a different car, the 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks

Remove UNDERBODY PROTECTION

Connect bleeder unit to brake fluid expansion tank.

IMPORTANT: Check relevant Operating Instructions for each device.
Charging pressure should not exceed 2 bar.

Connect bleeder hose to bleed valve (1).

Open bleed valve (1) and flush until clear brake fluid emerges without air bubbles.

Close bleed valve.

Fig 1: Identifying Bleed Valve

Courtesy of BMW OF NORTH AMERICA, INC.

Switch off bleeder unit or remove from brake fluid expansion tank.

Correct brake fluid level in expansion tank.