24 34 021 Replacing sealing sleeve for transmission housing (GA6HP19Z)

WARNING: This page is about a different car, the 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: After completion of work, CHECK TRANSMISSION OIL LEVEL .
Use only AUTOMATIC TRANSMISSION - OPERATING FLUIDS .
Failure to comply with this requirement will result in serious damage to the automatic transmission!

Necessary preliminary tasks

Remove heat shields
Remove TRANSMISSION FLUID SUMP
Remove TRANSMISSION CROSS-MEMBER .

IMPORTANT: Support transmission with workshop hoist.

Unlock and disconnect plug (1) by turning.

Fig 1: Turning Plug

G04726084

Courtesy of BMW OF NORTH AMERICA, INC.

Insert special tool 24 2 390 in sealing sleeve (1).

Fig 2: Inserting Sealing Sleeve Using Special Tool (24 2 390)

G04726133

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock sealing sleeve with slide (1).

Fig 3: Removing Sleeve With Slide

G04726136

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Note position of sealing sleeve.

Pull out sealing sleeve (1).

Installation:

Screw in sealing sleeve partially (lug in upper area). Turn until lug engages in groove of gearbox. Slide in sealing sleeve.

Lug on sealing sleeve must not be damaged!

Fig 4: Pulling Out Sealing Cup

G04726137

Courtesy of BMW OF NORTH AMERICA, INC.