13 62 010 Removing and installing/replacing differential pressure sensor (N52K)

WARNING: This page is about a different car, the 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Release screws.

Tightening torque 13 62 4AZ .

Unlock plug (1) and remove.

Pull differential pressure sensor (2) out of intake air manifold.

Fig 1: Identifying Differential Pressure Sensor And Plug

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Read out fault memory of control unit of Digital Motor Electronics (DME).

Check stored fault message.

Now clear the fault memory.