12 14 523 Replacing pulse generator on inlet camshaft (N52K)

WARNING: This page is about a different car, the 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Necessary preliminary tasks:

Read out fault memory of DME control unit
Switch off ignition

Unlock plug (1) and remove.

Release screw.

Installation:

Replace screw.

Tightening torque 13 62 1AZ .

Remove pulse generator (2).

Fig 1: Locating Pulse Generator With Plug

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Check stored fault messages.
Now clear the fault memory.