LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2013 >> Z4 28i, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 1429 (Cooling System - Repair (N55, 2013-)) >> Transmission Oil Cooler And Lines >> 17 21 500 Rinsing transmission oil cooler and lines

17 21 500 Rinsing transmission oil cooler and lines

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 BMW 740i, 2015 BMW 740Li xDrive, 2015 BMW 740Li, 2014 BMW 740i, and 2014 BMW 740Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required: 

NOTE: Carry out the operations listed when:
Install a new or exchange transmission.

Procedure: 

Automatic transmission removed.

Connect appropriate adapters (see description below) to oil lines exiting from automatic transmission.

Use quick-release coupling to connecting line 17 2 019 from oil dispenser unit.

Use quick-release coupling to drain line 17 2 018 .

Hold and direct open end of drain line into a suitable collecting vessel.

Using oil dispenser unit, flush approx. 1 liter of TRANSMISSION FLUID through oil lines and transmission oil cooler.

Reposition quick-release couplings.

Flush oil lines/transmission oil cooler in opposite direction with approx. 1 liter of TRANSMISSION FLUID .

Disconnect quick-release couplings.

Remove adapter.

Recycling: 

Never use flushing oil.

Dispose of flushing oil according to country-specific waste disposal regulations.

Press hydraulic lines (1) into adapters (2).

Slide clamping bracket (3) into guides and secure with screw (4).

Fig 1: Identifying Hydraulic Lines, Adapters, Clamping Bar And Screw
G05758972Courtesy of BMW OF NORTH AMERICA, INC.

Arrangement of flushing device for transmission GA8HP45Z, GA8HP50, GA8HP70Z, GA8HP75Z, GA8HP90Z 

  1. Transmission oil cooler with lines
  2. Oil dispenser unit

    17 2 015 Connection for oil dispenser unit (2), manufacturer: Deutsche Tecalemit or

    17 2 016 Connection for oil dispenser unit (2), manufacturer: Horn

    17 2 017 Quick-release coupling (2 pieces)

    17 2 019 Hose to oil dispenser unit (2)

  3. Oil drip tray

    17 2 018 Hose to oil drip tray (3)

  4. Adapter with clamping bracket

    17 2 080 Adapter with clamping bracket GA8HP45Z/GA8HP70Z/GA8HP90Z

  5. Fig 2: Identifying Transmission Flushing Device Arrangement (GA8HP45Z, GA8HP50, GA8HP70Z, GA8HP75Z, GA8HP90Z)
    G05758973Courtesy of BMW OF NORTH AMERICA, INC.