13 71 000 Removing and installing/replacing intake silencer housing (N55)

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 BMW 740i, 2015 BMW 740Li xDrive, 2015 BMW 740Li, 2014 BMW 740i, and 2014 BMW 740Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary work:

Remove intake duct

Detach line clip (1) from intake silencer housing in upward direction.

NOTE: For clarification purposes, the drawing does not show upper part of intake silencer housing installed.

Fig 1: Detaching Line Clip From Intake Silencer Housing

Courtesy of BMW OF NORTH AMERICA, INC.

Release clamp (1).

Tightening torque 13 71 3AZ .

Pull intake silencer housing (2) off rubber mounts in an upward direction and remove.

Fig 2: Pulling Intake Silencer Housing Upward

Courtesy of BMW OF NORTH AMERICA, INC.

Reassemble the vehicle.