63 12 870 Replacing ignition unit for left/right xenon headlight (with xenon bulb)
WARNING: This page is about a different car, the 2016 BMW Z4, 2015 BMW Z4, and 2014 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Version with xenon headlights: Danger to life due to high voltage! Therefore, before removing, disconnect all components from the voltage supply (lighting system and ignition off).
Work on the entire xenon lighting system (ignition device, control unit and bulb) may only be carried out by qualified personnel.
Work on the entire xenon lighting system (ignition device, control unit and bulb) may only be carried out by qualified personnel.
NOTE:
Front wheel removed for purposes of clarity.
Unlock fasteners (1) by turning counterclockwise through 180° and remove cover (2).
Turn protective cap (1) in the direction of arrow and remove.
Installation note:
Protective cap (2) must be correctly engaged.
Check seal.
Replace protective cap (2) if necessary.
Comply with INSTRUCTIONS FOR REPLACING THE PROTECTIVE CAP .
Disconnect plug connection (1).
Turn ignition unit for xenon headlight (2) approx. 30° counterclockwise and detach from headlight (3).
Installation note:
Make sure inner ring is correctly positioned in ignition unit for xenon headlight (2).
Recommendation:
Check HEADLIGHT ADJUSTMENT , correct if necessary.