Storage Location

WARNING: This page is about a different car, the 2016 BMW Z4, 2015 BMW Z4, and 2014 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Device (311000)

Courtesy of BMW OF NORTH AMERICA, INC.

Consisting of:

1 = 0491851 Spindle

NOTE: With 2 nuts and 2 washers

2 = 0491852 Bush

NOTE: (Slip bush) For installing the rubber mount in the front axle support

3 = 0491853 Bush

NOTE: (Bush) For removing the rubber mount from the front axle support, for removing and installing the rubber mount in the wishbones and for press- fitting the taper roller bearing of the rear axle differential housing

4 = 0491854 Pipe

NOTE: (Support tube) For installing the rubber mount in the front axle support - series: E12

5 = 0491855 Washer

NOTE: (Flanged washer) For centering of threaded spindle and as a support disc for removing and installing the rubber mount in the front axle support and in the wishbones - series: E12

6 = 0491856 Synchronizing key

NOTE: For removing and installing the rubber mount in the front axle support - series: E12

7 = 0491857 Bush

NOTE: For installing the rubber mount in the front axle support - series: E12

8 = 0491858 Bush

NOTE: (Bush) For installing the rubber mount in the front axle support and thrust piece, for removing and installing the rubber mount in the wishbones

9 = 0491859 Bush

NOTE: (Bush) Deletion, only available via tool set