41 33 040 Replacing Front Left Or Right Side Wall Holder

General information: 

Observe procedure REPAIR STAGE 2 .

Following new body parts are required:

• (1) Holder, side wall, front (variant 1)
• (2) Holder, side wall, front (variant 2)

Following CONSUMABLES  are required:

Fig 1: Identifying Front Holders - Side Wall (Variant 1 And 2)

Courtesy of BMW OF NORTH AMERICA, INC.

Removal of side wall holder (variant 1): 

Release welded connections in areas (1) and remove holder (2).

Fig 2: Identifying Side Wall Holder And Welded Connections Area (Variant 1)

Courtesy of BMW OF NORTH AMERICA, INC.

Preparation of new part: 

Adjust new part in conjunction with side panel in front to fit.

In area of bonding surfaces (1), set 2 4.2 mm dia. bore holes (2) for blind rivets N3.

Remove new part and deburr holes.

Fig 3: Identifying Bonding Surfaces Area With Blind Rivet Holes Area

Courtesy of BMW OF NORTH AMERICA, INC.

Installation of side wall holder: 

Clean all bonding surfaces with cleaning agent R1.

Apply adhesive to bonding surfaces.

Install new part and rivet with blind rivets.

Removal of side wall holder (variant 2): 

Release welded connection in area (1) and remove holder (2).

Fig 4: Identifying Side Wall Holder And Welded Connections Area (Variant 2)

Courtesy of BMW OF NORTH AMERICA, INC.

Preparation of new part: 

Fit in new part.

In area of adhesive surface (1), drill a 4.2 mm dia. bore hole (2) for blind rivet N3.

Remove new part and deburr holes.

Fig 5: Identifying Adhesive Surface And Blind Rivet (N3) Hole Area

Courtesy of BMW OF NORTH AMERICA, INC.

Installation of side wall holder: 

Clean all bonding surfaces with cleaning agent R1.

Apply adhesive to bonding surface.

Install new part and rivet with blind rivet.