54 37 024 Replacing rear roof shell seal

WARNING: This page is about a different car, the 2016 BMW Z4, 2015 BMW Z4, and 2014 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Partially open soft top

Remove seal (1).

Installation:

Slide seal flush onto front roof shell seal.

Make sure seal (1) is SECURELY MOUNTED on seal carrier.

Fig 1: Removing Rear Roof Shell Seal

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Count and make a note of washers.

Release left and right screws (1).

Installation:

Adjust gap dimension, seal carrier to roof shell.

= 2 mm ±1 mm

If necessary, adapt number of washers.

Fig 2: Identifying Roof Shell Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Grease contact points of seal carriers with Vaseline.

Slide seal carrier (1) fully onto front roof shell seal and screw down.

If necessary, adjust SEAL CARRIER , front roof shell.

Tightening torque 54 37 14AZ .

Fig 3: Locating Contact Points Of Seal Carriers

Courtesy of BMW OF NORTH AMERICA, INC.

Detach seal (1) from seal carrier.

Installation:

Make sure seal (1) is correctly seated on seal carrier.

Fig 4: Detaching Seal From Seal Carrier

Courtesy of BMW OF NORTH AMERICA, INC.

Check retraction depth of windows and adjust if necessary. See ADJUSTING REAR SIDE WINDOW and ADJUSTING FRONT SIDE WINDOW .