65 12 072 Removing and installing (replacing) amplifier (Top Hi-Fi system)

WARNING: This page is about a different car, the 2016 BMW Z4, 2015 BMW Z4, and 2014 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.

Remove AMPLIFIER

NOTE: Until 09/2009 a Top Hi-Fi amplifier with a different pin assignment is installed!

Remove socket (1) from connector (3).

Create wire jumper (2) from wire (cross-section 0.75 mm² ) and two stops.

Then connect pins 1 and 2 in the socket (1) with wire jumper (2).

NOTE: In contrast to the figure, contacts 3 and 4 of the socket (1) can be assigned!

Fig 1: Identifying Cable Jumper, Wire Jumper, Connector And Connector Chamber

Courtesy of BMW OF NORTH AMERICA, INC.

Connector chamber (4) is not included in current version and remains unused in new replacement Top Hi-Fi amplifier!