64 11 909 Removing and installing/replacing footwell temperature sensor

WARNING: This page is about a different car, the 2016 BMW Z4, 2015 BMW Z4, and 2014 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove TRIM FOR INSTRUMENT PANEL AT BOTTOM LEFT

Remove footwell duct (1).

Fig 1: Identifying Footwell Duct

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Turn temperature sensor (2) at plug socket as far as it will go.

Feed temperature sensor (2) out of footwell duct.

Installation:

Make sure temperature sensor (2) is correctly engaged in footwell duct.

Fig 2: Installing Temperature Sensor In Footwell Duct

Courtesy of BMW OF NORTH AMERICA, INC.