13 71 000 Removing and installing/replacing the intake silencer housing (N54, N54T)
WARNING: This page is about a different car, the 2016 BMW Z4, 2015 BMW Z4, and 2014 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove intake duct.
Unlock and disconnect line (1).
Unclip line (1) from the intake silencer housing.
Release clamp and detach air intake hose.
Tightening torque 13 71 5AZ .
Release clamp and detach air duct.
Tightening torque 13 71 5AZ .
Pull wiring harness mounting (1) up.
Detach intake silencer housing (2) from bearing journal and remove.
Installation note:
Ensure correct seating of the intake silencer housing on the bearing journal.